Direct-Pure RO Lab Water Systems

The Direct-Pure RO lab water system produces reverse osmosis (RO) water from tap water directly.

Electrical and water compartments are completely segregated, thus safer to operate.
The Fully automated control system contains pre-rinse, RO membrane fouling preventing flush, RO membrane life detection as well as many other programs for convenient operation.
The pre-rinsing program starts automatically when a new RO membrane is installed so there is no need for users to set up additional cleaning procedures.
The system is equipped with a 30-liter PE tank (upgradeable to a 60-liter) with a liquid level sensor.
RephiLe can provide full document support to meet users’ GMP, GLP, FDA and other certification requirements.
The handle is 360 degree-rotatable and detachable from its support for effortless and instant dispensing with maximum flexibility.

Feed Water Requirements
Tap water*	Municipal water, TDS < 1000 ppm (2000 μS/cm)
Operating Temperature	5～45 ℃
Feed Water Pressure	15 - 90 psi (1 - 6 bar)
Product Water Flow Rate	10 to 30 L/h at 25 ℃
RO Rejection Rate
Monovalent ions removal	>95%
Polyvalent ions removal	>99%
Bacteria and Particles removal	>99%
Organics and Pyrogens removal	>99%
Dimensions
Length x Depth x Height	30 cm × 51 cm × 48 cm
Net Weight (Operating Weight)	18 - 21 kg

* If water hardness is less than 180 ppm, RephiLe suggests using RephiTEKT RW50211KT.

If water hardness is greater than 180 ppm, RephiLe suggests using an additional water softening device to protect the RO membrane in your system.